FIRST TIME SETUP
Follow these simple steps to get your H5 High Pressure Washer ready for action.
Unpack and Inspect
Remove the machine and all accessories from the box. Verify you have the gun, lance, hose, water filter, and nozzle pin.
Install Water Inlet Filter
Screw the transparent water filter onto the machine's water inlet (usually at the front or side). This protects the pump from debris.
Connect High Pressure Hose
Connect one end of the 8M high-pressure hose to the machine's outlet. Ensure it clicks or screws in securely.
Assemble Lance and Gun
Attach the extension lance to the trigger gun. Insert it and twist to lock it into place. Connect the other end of the high-pressure hose to the gun.
Connect Water Supply
Using a standard garden hose (equipped with the Quick Connector), connect your water tap to the machine's Water Inlet Filter.
Purge Air (Critical Step)
Turn on your water tap. Do NOT turn on the machine power yet. Squeeze the gun trigger to let water flow through. Wait until a steady stream of water comes out, removing all air bubbles.
Power On & Clean
Plug the machine into a power outlet. Switch the machine ON. You are now ready to clean!